On/Off Switch - Ryobi RDP102L Manual De Utilización

EN
FR DE ES IT NL
opEration
warninG
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
warninG
Always wear safety goggles or safety glasses with
side shields when operating power tools. Failure to do
so could result in objects being thrown into your eyes
resulting in possible serious injury.
warninG
Do not use any attachments or accessories not
recommended by the manufacturer of the product. The
use of attachments or accessories not recommended
can result in serious personal injury.
warninG
To avoid possible injury, keep guard closed and in place
while tool is in operation.
cHanGinG spEEDs anD BElt placEMEnt
See Figure 24.
The spindle speed is determined by the location of the belt
on the pulleys inside the head assembly. The speed chart
located on the cover inside the head assembly shows the
recommended speed and pulley configuration for each
drilling operation.
To change the pulley configuration:
1. Lift pulley cover.
2. Loosen the tension bolt.
3. Remove the belt.
4. Reposition the belt according to the speed chart.
5. Retighten the tension bolt.
notE: Refer to the "Recommended Drilling Speed" section
for size of drill bit and drilling speed recommendations.
rEcoMMEnDED DrillinG spEED
DRILLING SPEED TABLE (RPM)
Drill bit
diameter
Wood
(Inches)
Plastics
PT DA SV FI NO RU
English
Material
Aluminium Iron
Zinc Steel
Brass
PL CS HU RO LV LT
1/16 2430
1/8
3/16
1/4
5/16
3/8
1/2 1800

on/off switch

See Figure 25.
to turn the drill press on:
1. Press the ON button ( l ).
to turn the drill press off:
1. Press the OFF button ( O ).
Always make sure the workpiece is not in contact with
the bit before operating the switch to start the product.
Failure to heed this warning may cause the workpiece
to be kicked back toward the operator and result in
serious personal injury.
installinG anD rEMovinG Bits
See Figure 26.
1. Unplug the drill press.
2. Open or close the chuck jaws to a point where the
opening is slightly larger than the bit size you intend
to use.
3. Insert drill bit into the chuck the full length of the jaws.
Do not insert drill bit into chuck jaws and tighten as
shown in Figure 19. This could cause drill bit to be
thrown from the drill press, resulting in possible serious
personal injury or damage to the chuck.
4. Tighten chuck jaws securely using chuck key provided.
Do not use a wrench to tighten or loosen chuck jaws.
5. Remove chuck key.
6. To remove the drill bit, reverse the steps listed above.
9
ET HR SL SK BG UK
2430 2430
1800
1300
1800
800
1300
800 510
warninG
warninG
TR EL