Edirol STUDIOCANVAS SD-80 Guía De Iniciación página 20

Installing & Setting Up the Driver (Windows)
7
Use the USB cable to connect the SD-80 to your computer.
1. With the power switch turned OFF, connect the AC cable to the SD-80.
2. Connect the AC cable to an electrical outlet.
3. Use the USB cable to connect the SD-80 to your computer.
8
Set the SD-80's power switch to the ON position.
fig.2-20_30
9
If you are using Windows 98, an
Insert Disk dialog box will
appear. Click [OK].
10
The New Hardware Found dialog box will appear.
Input the following into the "Copy files from" field, and click [OK].
fig.2-21a_40
D:\Driver\USB_ME98
* The drive name "D:" may be different
for your system. Specify the drive
name of your CD-ROM drive.
11
Once the driver has been
installed, New Hardware Found dialog box will close.
In the SetupInf dialog box, click [OK]. The SETUPINF dialog box will close.
Next, you need to make the driver settings.
(-> MIDI input and output destinations (p. 21)
If you were not able to install the SD-80 driver according to the procedure, or
if you are unable to use the SD-80 even after installing the driver, you must
delete the driver. For details on how to delete the driver, refer to Deleting the
driver (p. 39).
After deleting the driver, use the procedure described in "Installing &
Setting Up the Driver (Windows)" (p. 9) to re-install the driver.
20
Once the connections have
been completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
Always make sure to have
the volume level turned
down before switching on
power. Even with the
volume all the way down,
you may still hear some
sound when the power is
switched on, but this is
normal, and does not
indicate a malfunction.
If you are using
Windows 98 and the
Insert Disk dialog box
dose not appear, please
read The "Insert Disk"
dialog box does not
appear (p. 35).
If the New Hardware
Found dialog box does not
appear, re-install the
driver using the same
procedure as described in
The "Insert Disk" dialog
box does not appear
(p. 35).