Edirol STUDIOCANVAS SD-80 Guía De Iniciación página 72

Fehlerbehebung
• Was the driver installed correctly?
In order for you to play back audio data via the SD-80, the driver must be installed. For installation
and settings, refer to "Installing & Setting Up the Driver" (Windows, S. 44 / Macintosh, S. 60).
• Is your audio playback equipment (e.g., stereo system) connected correctly?
On its own, the SD-80 is not capable of producing sound that you can hear. Make sure that the USB
connector of your computer is connected to the SD-80 by a USB cable. Make sure that the SD-80's
OUTPUT 1 (audio output 1) jacks are connected by audio cables to the input jacks of your audio
playback equipment. For details on connections, refer to "Anschluss von Audiogeräten" (S. 43).
• Is the power of your audio equipment turned on?
Make sure that the power is turned on for your audio equipment (e.g., stereo) and the SD-80.
• Are the various volume settings of the SD-80 set appropriately?
The front panel of the SD-80 has separate knobs that adjust the MIDI volumes. Use the Volume
knob located on the front panel of the SD-80 to adjust the volume.
• Is your computer in Suspend or Sleep mode?
If so, get your computer to resume normal operation, then exit all applications that are using the
SD-80. Next, turn the SD-80's power off, then switch it on again.
• Did you reconnect the USB cable or turn the power of the SD-80 off and on?
Exit all applications that are using the SD-80, and turn the power of the SD-80 off and then on once again.
• Is OMS/FreeMIDI set correctly?
As described in "OMS-Einstellungen" (S. 62) or "Einstellungen für FreeMIDI" (S. 65), check the
OMS or FreeMIDI settings. Also make sure that the device for MIDI IN/OUT is correctly selected
in the MIDI settings of your MIDI sequencer software.
• Does the PART level meter move in the SD-80 display?
If the PART level meter is moving but you do not hear sound, check whether the volume of the SD-80
or your speakers has been lowered. If the PART level meter of the SD-80 is not moving, recheck the
connections and "OMS-Einstellungen" (S. 62)/"Einstellungen für FreeMIDI" (S. 65).
• Is the OMS setup enabled?
If a diamond-shaped symbol is not displayed at the left edge of the title area in the OMS setup
window, the setup is not enabled. From the OMS File menu, choose "Enable setup".
("OMS-Einstellungen" (S. 62))
• Has your computer been set to enter Sleep mode?
If your computer enters Sleep mode, exit the software you are using, and then restart your
computer. We recommend that you set your computer to not use Sleep mode.
72