Remote; Dccs - Avtech IVS Manual De Instrucciones

5.5.8 REMOTE

CANERA CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11
DETECTION DEVICE
ALERT ID
NETWORK PROTOCOL
SNTP RATE
DISPLAY
RECORD
REMOTE

DCCS

IVS
NOTIFY
EXIT
1) DEVICE
For the PTZ camera, select "PTZ".
For a zoom lens control camera:
The DVR will detect it automatically and display its model number here.
To configure the parameters for a zoom lens control camera, please refer to "5.5.9 DCCS" at page 27. Different zoom lens control
cameras might have different parameter settings. For details, please refer to their own user manuals.
2) ID
Click the current value to set the ID number (0 ~ 255) for the connected PTZ camera if necessary.
Make sure the ID setting of the camera is the same as the setting here, or the DVR will not be able to control
the device.
Note: To know the default ID of the PTZ camera, please refer to its user manual.
3) PROTOCOL
Select NORMAL (our protocol), P-D (PELCO-D) or P-P (PELCO-P) protocol.
4) RATE
Select the baud rate for the connected PTZ camera (2400 / 4800 / 9600 / 19200 / 57600 / 115200).
Make sure the baud rate setting of the camera is the same as the setting here, or the DVR will not be able to
control the device.
Note: To know the default baud rate of the PTZ camera, please refer to its user manual.
5.5.9 DCCS
Note: For 16CH models, only channel 1, 5, 9 & 13 support DCCS camera connection;
For 8CH models, only channel 1 & 5 support DCCS camera connection;
For 4CH models, only channel 1 supports DCCS camera connection.
CANERA CH1 CH2 CH3 CH4
DETECTION DIAGNOSTIC
ALERT MENU
NETWORK
SNTP
DISPLAY
RECORD
REMOTE
DEVICE
DCCS
CONNECTION
IVS
NOTIFY
EXIT
1) DIAGNOSTIC
Click "START" to start examining the DCCS signal transmission between the DVR and the camera. The
ADVANCE CONFIG
PTZ
00
NORMAL
2400
ADVANCE CONFIG
START
SETUP
AVK523
OK
27
MAIN MENU