Tabla de contenido
Publicidad
5. Push the release hook inside the finger hole and pull the spacers out of the
backrest.
6. Repeat this procedure on the other side of the backrest.
7. Operate the ISOFIX-Connect-adjustment handle (l) and pull the two ISOFIX-
Connect-locking arms (k) out.
8. Keep the ISOFIX-Connect-adjustment handle (l) held and release the two
snap clips (u) on the underside of the booster (e), one after the other and
pull the ISOFIX-Connect loking arms (k) out of the base. If necessary, use
a screwdriver.
9. Push the ISOFIX-Connect-locking arms (k) into the designated openings on
the underside of the booster (e) until there is some resistance.
10. Operate the position adjustment button (r) on the underside and push the
ISOFIX-Connect-locking arms (k) as far in as possible.
Note the minimum drop height of the ISOFIX-Connect-locking arms.
��
Ensure that the locking arms (k) are installed the right way around and that
��
the teeth of the locking arms are up.
When reassembling the seat, proceed in precisely the reverse order. Use
��
the instructions to check beforehand if all parts are present.
SECURING THE CHILD WITHOUT IMPACT SHIELD – GROUP 2/3
(15–36 KG)
1. Route the vehicle seat belt around your child and insert the belt tongue into
the belt buckle. It must lock into place with an audible "CLICK".
2. Place the lap belt in the red coloured lap belt guides (h) of the car seat.
3. Pull the shoulder belt to tighten the lap belt.
4. On the side of the car seat next to the belt buckle, the shoulder belt and the
lap belt must be inserted together in the lap belt guide (h).
5. Feed the shoulder belt through the shoulder belt guide (i) until it is inside
the belt guide.
6. Ensure that the shoulder belt runs across your child's clavicle and does not
touch your child's neck. If necessary, adjust the height of the headrest (c) to
change the position of the belt.
REMOVING AND REATTACHING THE SEAT COVER
The cover of the car seat consists of 4 parts (headrest, backrest, booster and
impact shield). These are held in position at several places by press-studs.
Once all studs have been released, the single parts of the cover can be
removed.
In order to put the covers back on the car seat, follow the removal instructions
in the reverse order.
The cover may only be washed at 30 °C with a delicate wash program
��
otherwise it may result in discolouration of the cover fabric. Please wash
the cover separately from other laundry and do not dry in the dryer or in
direct sunlight!
MANUFACTURER'S WARRANTY AND DISPOSAL REGULATIONS
CYBEX GmbH (Riedingerstr. 18, 95448 Bayreuth, Germany) gives you
3 years warranty on this product. The warranty is valid in the country, where
this product was initially sold by a retailer to a customer. The contents of
the guarantee and all essential information required for the assertion of
the guarantee can be found on our homepage go.cybex-online.com/
manufacturer-warranty-car-seats. If a warranty is shown in the article
description, your legal rights against us for defects remain unaffected.
Please observe the waste disposal regulations in your country.
EN
9
Publicidad
Tabla de contenido
