5.5
Coupling and uncoupling attachment units
EN
5.6
Steering the machine
5.7
Leaving the machine
120
Coupling
•
Clean the connecting piece of the machine and of the attachment unit.
•
Grease the teeth of the PTO shaft and the connecting piece.
•
Open the attachment unit lock.
•
Push the attachment unit into the machine connecting piece.
•
Close the attachment unit lock.
•
Move the attachment unit or the machine until the attachment unit lock engages.
Uncoupling
•
Secure the machine against rolling away again.
•
Open the attachment unit lock and uncouple the attachment unit.
•
Close the attachment unit lock.
The machine can suddenly trap the user or third persons, cause them to fall over or run
them over.
•
After coupling attachment units, check whether the attachment unit locking bolt is
engaged and the attachment unit is connected to the machine.
The machine can suddenly trap the user or third persons, cause them to fall over or run
them over, crush or lacerate them.
•
Coupling and uncoupling attachment units may only be done when the engine is turned
off.
The machine is steered by exerting lateral force on the handlebar.
The machine can suddenly trap the user or third persons, cause them to fall over or run
them over.
•
The machine cannot be steered when the differential is locked.
•
Turn the forward/reverse control to 0 position.
•
Deactivate the PTO shaft drive.
•
Apply the parking brake.
•
Remove the ignition and starter switch (only in conjunction with an electric starter).
•
Place the machine on a motor protection plate without the attachment unit. The
handlebar ends must not contact the ground, adjust the handlebar height accordingly.
The machine can suddenly trap the user or third persons, cause them to fall over or run
them over.
•
Never leave the machine while the engine is running.
•
Secure the machine against rolling away and unauthorized use.
Warning
Danger
Warning
Warning
Machine no. from CI 1001