Changing Hydraulic Oil And Filters - Rapid Mondo 1550 Manual De Instrucciones

7.4

Changing hydraulic oil and filters

EN
7.5 Lube layout
128
Change the hydraulic oil
• Dismount the base plate
• Dismount the side cover
• Dismount the drain plug (A)
• Drain off oil
• Dismount old oil filter (B)
• Apply oil to the sealing ring on the new oil
filter
• Mount a new oil filter
• Mount the drain plug (A)
• Mount the base plate
• Dismount the oil level plug (C)
• Bring the machine into a horizontal
position.
• Dismount the filling and air ventilating
screw (D)
Attention: Do not disconnect ventilation
valve from the screw-in nipple (press-fit)
• Pour oil into opening at the filling and air
ventilation screw until level (E) is reached
• Mount the filling and air ventilating screw
(D)
• Mount the oil level plug (C)
• Let the engine idle for approx. 2 minutes.
• Slowly drive the machine forwards and
backwards.
• Turn off the engine
• Dismount the oil level plug (C) and check
the oil level (E), top up if necessary.
• Mount the oil level plug (C)
• Mount the side cover
Oil level check
• Normal oil level (E)
1) Handlebar bearing
2) Connecting piece
3) Lubricate PTO shaft
Lubricating grease
Lithium soap base NLGI 2 (multi-purpose
grease)
Machine no. from CI 1001