Maintenance - Rapid Mondo 1550 Manual De Instrucciones

7

Maintenance

EN
124
It is assumed that you have read and understood the chapters "First things first" and "Safe
operation".
• After cleaning, all parts must be lubricated according to the maintenance schedule.
• Check nuts and screws according to the maintenance schedule for firm seating.
• When topping up with hydraulic oil, maximum cleanliness is required.
• Check hydraulic hoses and tubes acc. to the maintenance schedule for damage and
aging, replace if necessary.
• The electrical system must be checked for damage and function acc. to the maintenance
schedule.
• If the machine is not to be used for more than 2 months it is recommended to close the
fuel valve while the engine is running and to wait until the engine stops. Make absolutely
sure to avoid fuel staying in the carburetor for longer periods of time.
• Always make sure that the battery is well charged, if necessary charge the batteries with
the battery charger. Charging 12 V 0.6 A with an automatic mains charger.
The machine can suddenly trap the user or third persons, cause them to fall over or run
them over.
• Cleaning and maintenance work and the removal of safety equipment must only be
carried out when the engine is
socket.
• Replace defective parts.
• The hydraulic system may be pressurized.
• When searching for leakages, suitable protection must be used (goggles and gloves).
• The machine must be cleaned thoroughly before any work is done on the hydraulic
system. Maximum cleanliness is required.
• Repairs in the hydrostat must only be carried out by an authorized Rapid dealer.
Note
Caution
off and the parking brake is applied. Pull the spark plug
turned
Machine no. from CI 1001