Power Switch - Warm Audio WA-8000 Manual De Instrucciones

FEATURES
1. CONTENTS
Your WA-8000 package includes the WA-8000 microphone itself, external power supply,
IEC power cable, shock mount, Gotham GAC-7 cable, and custom hard case.

2. POWER SWITCH

The power switch is located on the power supply. Always turn the power supply off before
connecting or disconnecting cables.
We recommend turning the power supply on at least 30 minutes before using the mic. This
will enable the tube and components to reach optimal operating temperature and deliver
the best performance.
3. IEC POWER INLET
The IEC power inlet is located on the rear side of the power supply and allows a standard
IEC coble to connect the power supply to your wall power outlet.
4. 110V /230V VOLTAGE SELECTOR SWITCH
A protected voltage selector switch is located near the IEC inlet on the power supply,
which allows you to set the appropriate operating voltage for the country where you use
the microphone. The voltage selector switch will be pre-set to reflect the operating voltage
of the country where the product was purchased and should not be changed, unless the
mic is physically moved to another country or region of the world where the voltages are
different.
5. 7-PIN MICROPHONE CABLE CONNECTOR (FEMALE)
A 7-pin female microphone cable connector is located on the power supply. The Gotham
GAC-7 cable is connected to this connector on one end and to the WA-8000 microphone
on the other.
6. XLR OUTPUT
A standard 3-pin XLR male connector is located on the power supply. The microphone's
signal will exit via this connector, so attach a high-quality preamp here via a standard
3-pin XLR microphone cable.
7. POLAR PATTERN SELECT SWITCH
The polar-pattern selection switch is located on the front of the microphone, and it allows
you to select between omni-directional and cardioid patterns.
Reference images on following page.
4