Skymsen ML Manual De Instrucciones página 21

PROBLEMS
- The appliance doesn´t
turn on.
- Burn smell and/or smoke.
- The appliance turns on but
when the product is placed in
the equipment, it stops or it
turns into slow rotation.
- Damaged electric cable
- Blade breaks frequently
- Difficulties to cut the product
- Strange noises
FRAME 02
CAUSES
- The machine is not connected
to the power grid.
- Lack of power.
- Problem with the internal or
external electrical circuit.
- Problem with the internal or
external electrical circuit.
- Belt slipping on pulleys.
- Damaged Motor.
- Failure on the product
transportation
- Dirty Blade or Wheel.
- Damaged wheel.
- Dirty blade or wheels;
- Blade with wrong tension;
- Blade is not on wheels center;
- Blunt blade.
- Blade skidding on the
wheels.
- Blade incorrectly welded.
SOLUTIONS
- Connect the machine's
power cable to the mains.
- Check if the electricity is on.
- Call the Authorized Technical
Assistance (ATA).
- Call the Authorized Technical
Assistance (ATA).
- Rotate the knob No. 02 (fig.
04) to increase the pressure
between the blade and the
wheels.
- Change the Blade
- Check the power connection
- Call the Authorized Technical
Assistance (ATA).
Call the Authorized Technical
Assistance (ATA).
- Clean,see the item 3.3
CLEANING
- Replace wheels.
- Call the Authorized Technical
Assistance (ATA).
- Clean, see the item 3.3
CLEANING;
- Adjust the blade tension, see
item 3.2.4
- Call Technical Assistance.
- Change the Blade
- Call the Authorized Technical
Assistance (ATA).
21