eng
Section B: Reclined Cradle Mode
– suitable for 0 – 6 months (refer to
illustrations section b)
WARNINGS:
• Do not use the reclined cradle once your
child can sit unaided.
• Reclined cradle mode is intended for
children with a maximum weight of 9kg /
20 lbs.
• Never leave the child unattended when the
baby chair is in reclined cradle mode.
• The child should be secured in the baby
chair at all times by the 5-point safety
harness in reclined cradle mode.
• It is dangerous to put this reclined cradle on
an elevated surface.
• Keep the product away from open fire,
heaters and other sources of strong heat.
• Do not use the product unless all
components are correctly fitted and
adjusted.
• Make sure harness is correctly fitted before
use.
• This reclined cradle is not intended for
prolonged periods of sleeping.
• It is dangerous to put this baby chair on an
elevated surface.
• This reclined cradle does not replace a
cot or a bed. Should your child need to
sleep, then your child should be placed in a
suitable cot or bed.
• Do not use accessories or replacement
parts other than those approved by the
4
manufacturer.
• Do not use the reclined cradle if any
components are broken or missing.
• Always use the restraint system.
To Install Seat Pad & Safety Harness Assembly
– (#07 seat pad, #09 safety harness) Put
shoulder straps through the seat pad slits at
the lower height setting.
– Put waist straps through the seat pad slits.
– Place seat pad onto the seat unit; secure onto
velcro. (refer to illustration b1)
– (#04 seat unit) Behind the seat pad, slide the
buckle on the end of the shoulder straps into
the buckle slots located on the inner face of
seat unit. (refer to illustration b2) Check the
straps are secured by pulling on the straps.
– (#12 storage compartment) Behind the seat
pad, pull open the storage compartment door
located on the inner face of seat unit. Slide
the buckle on the end of the waist straps into
the buckle slots on either side of the storage
compartment. Check the straps are secured
by pulling on the straps.
– (#14 crotch cover) Press the button on the
crotch cover and remove from the seat unit.
– Insert the loop on the end of the crotch strap
through the upper hole of the crotch strap
cover, and then put the loose end under the
crotch strap cover. Then slide the crotch strap
cover into the seat unit. The strap and buckle
must not be twisted or inverted. This will
ensure correct locking of the harness. (refer to
illustration b3)