Descargar Imprimir esta página

Stryker 6254 Manual De Uso página 15

Ocultar thumbs Ver también para 6254:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 123
F F i i g g u u r r e e 3 3 – – H H e e a a d d , , c c h h e e s s t t , , a a n n d d a a n n k k l l e e r r e e s s t t r r a a i i n n t t s s t t r r a a p p
a a t t t t a a c c h h m m e e n n t t p p o o i i n n t t s s - - f f r r o o n n t t v v i i e e w w
Buckle one restraint strap across the occupant's chest and the other across the occupant's lap. Buckle the ankle restraint
strap across the occupant's legs.
Secure restraint straps to the product in the required attachment locations (Figure 3 and Figure 4). Restraint strap
attachment locations should provide strong anchorage and proper restraint position. Do not allow restraint straps to
interfere with equipment or accessories. Buckle restraint straps when the chair is not in use.
Open the restraint straps and place them at either side of the chair while you position the occupant on the seat. Lengthen
the restraint straps, buckle them around the occupant, and shorten them to tighten.
To open the restraint strap, press the tabs on the side of the buckle receiver. This allows you to release the buckle latch
plate and pull it out of the receiver.
To close the restraint strap, push the latch plate into the receiver until you hear a click.
To lengthen the restraint strap, grasp the buckle latch plate, turn at an angle to the webbing, then pull out. A hemmed
tab at the end of the webbing prevents the latch plate from coming off of the restraint strap.
To shorten the restraint strap, grasp the hemmed tab and pull the webbing back through the latch plate to tighten.
When you buckle a restraint strap around an occupant, secure the latch plate and remove any loose webbing from the
chair.
A A t t t t a a c c h h i i n n g g t t h h e e c c h h e e s s t t r r e e s s t t r r a a i i n n t t s s t t r r a a p p s s
To attach the chest restraint straps in the cross-chest configuration:
1. Wrap each restraint strap around the chair frame. Insert the end of the restraint strap through the loop. Pull the restraint
strap tight.
2. Pull the restraint strap across the occupant's chest. Lengthen the restraint strap as necessary.
3. Buckle the restraint strap.
4. Pull the loose end of the restraint strap to tighten it around the occupant.
5. Repeat for the second restraint strap and the lap restraint strap.
6254-109-005 Rev C.0
F F i i g g u u r r e e 4 4 – – L L a a p p r r e e s s t t r r a a i i n n t t s s t t r r a a p p a a t t t t a a c c h h m m e e n n t t p p o o i i n n t t s s - - t t o o p p
v v i i e e w w
11
EN

Publicidad

loading