Installation; The Right Place For Installation; Attaching The Plastic Wedges - Grundig GSBS23340FXPN Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 49
4

Installation

4.1 The right place for installation

A
Read the "Safety
Instructions" section first!
Your product requires adequate air
circulation to function efficiently. If the
product will be placed in an alcove,
remember to leave at least 5 cm
clearance between the product and the
ceiling, rear wall and the side walls.
If the product will be placed in an
alcove, remember to leave at least 5
cm clearance between the product
and the ceiling, rear wall and the side
walls. Check if the rear wall clearance
protection component is present at its
location (if provided with the product).
If the component is not available, or if it
is lost or fallen, position the product so
that at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance
at the rear is important for efficient
operation of the product.
A
WARNING:
or multi sockets in power
connection.
WARNING:
B
assumes no responsibility for
any damage caused by the work
carried out by unauthorized
persons.
WARNING:
power cable must
B
be unplugged during
installation. Failure to do
so may result in death or
serious injuries!
10
Do not use extension
The manufacturer
The product's
WARNING:
span is too narrow for the
A
product to pass, remove the
door and turn the product
sideways; if this does not
work, contact the authorized
service.
Place the product on a flat surface to
avoid vibration.
Place the product at least 30 cm away
from the heater, stove and similar
sources of heat and at least 5 cm away
from electric ovens.
Do not expose the product to
direct sunlight or keep in damp
environments.
The product requires adequate air
circulation to function efficiently. If the
product will be placed in an alcove,
remember to leave at least 5 cm
distance between the product and the
ceiling and the walls.

4.2 Attaching the plastic wedges

Use the plastic wedges in the
provided with the product to provide
sufficient space for air circulation
between the product and the wall.
1-
To attach the wedges, remove the
screws on the product and use the
screws provided with the wedges.
Refrigerator / User Guide
10 /44 EN
: If the door

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido