Limit Switch; Normal Cutting; Miter Cutting - LEMAN SRM170 Manual De Instrucciones

LIMIT SWITCH

Fig 4
When the cutting is completed, the band saw is stopped.

6.5 NORMAL CUTTING

After carrying out the operations required for machine start-up, follow the instructions below:
- Place the material to be cut in the vice and clamp it firmly.
- Press the total switch in order to energize the machine.
- Select the required cutting position on the option switch.
- The band saw is now ready to cut.
(1) Grasp the handgrip control (A Fig 1) and press the push button in order to start the blade rotation.
(2) Press the main switch (c Fig 47 & 48) in order to start the blade rotation.
Rest the blade lightly on the piece to be cut, in order to avoid breaking the teeth, and execute the cut.
Ensure that the coolant comes out in a sufficient quantity during the cutting operations. The blade must be well
lubricated.
WARNING!
The machine is equipped with a low voltage electrical system (24V) with a minimum voltage and thermal protection
device. With this device, if voltage is disconnected, the machine stops and does not restart work, the start push
button must be activated. In this way, risks from accidental restarting of the machine are avoided.
CAUTION!
During normal operation if the band saw stops and the main switch has not been turned to "OFF" (or "0") and press
emergency "red mushroom", determine the cause for the stop, but take care as this is a hazardous situation.
DANGER!
ALL THE PRELIMINARY OPERATIONS FOR THE CUT MUST BE CARRIED OUT WHEN THE MACHINE BOW
IS IN STANDBY POSITION AND THE SAW BLADE IS NOT ROTATING.

6.6 MITER CUTTING

It is possible to perform miter cutting (max. 60
H
Fig 34
21-H16
21-H13
Fig 5
o ).
Fig 35
34
80 69
Fig 36