Makita 2107F Manual De Instrucciones página 6

Sierra de banda portátil
Ocultar thumbs Ver también para 2107F:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

holder and lower holder.
2
1
3
4
006193
Start and stop the tool two or three times to make sure
that the blade runs properly on the wheels.
CAUTION:
While making sure that the blade runs on the wheels
properly, keep your body away from the blade area.
To remove the blade, follow the installation procedure in
reverse.
CAUTION:
When turning the blade tightening lever clockwise
to release the tension on the blade, point the tool
downward because the blade may come off
unexpectedly.
Adjusting the protrusion of stopper plate
B
A
3
006194
Protrusion of the stopper plate to the blade can be
adjusted.
In the ordinary operation, protrude the stopper plate to
the A side fully.
When the stopper plate strikes against the obstacles like
a wall or the like at the finishing of a cut, loosen two
screws and slide it to the B side in the figure.
After sliding the stopper plate, secure it by tightening two
screws firmly.
1. Upper holder
2. Lower holder
3. Wheel
4. Press
1
1. Screw
2. Stopper plate
3. Blade
2
OPERATION
It is important to keep at least two teeth in the cut. Select
the proper cutting position for your workpiece by referring
to the figure.
004747
Hold the tool by both hands as shown in the figure with
the stopper plate contacting the workpiece and the blade
clear of the workpiece.
006195
Turn the tool on and wait until the blade attains full speed.
Gently lower the blade into the cut. The weight of the tool
or slightly pressing the tool will supply adequate pressure
for the cutting. Do not force the tool.
As you reach the end of a cut, release pressure and,
without actually raising the tool, lift it slightly so that it will
not fall against the workpiece.
CAUTION:
Applying excessive pressure to the tool or twisting of the
blade may cause bevel cutting or damage to the blade.
When not using the tool for a long period of time,
remove the blade from the tool.
When cutting metals, use Makita cutting wax as a cutting
lubricant. To apply the cutting wax to the blade teeth,
start the tool and cut in to the cutting wax as shown in the
figure after removing a cap of the cutting wax.
1
006196
6
1. Cutting wax

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

2107fz

Tabla de contenido