Tabla de contenido
Publicidad
8
ADJUSTMENTS
8.12
HANDLE ADJUSTMENT____________________________________________
The height of the handle can be adjusted in two ways
to suit the operator.
Where the tubes are attached to the side frames [A]
(Fig 8.12a) and where the handlebars are attached to
the lower handle tube [A] (Fig 8.12b).
To adjust the height:
1.
Slacken the clamp bolts [B] (Fig 8.12a) to adjust
the angle on the handlebars
Retighten the bolts.
2.
For vertical handlebar adjustment remove the
coach bolt from the handlebars, then replace in
appropriate slot, [B] (Fig 8.12B) retighten bolt.
8.13
MARQUIS: SIDE ROLLS __________________________________________
To allow long grass to the cut, the centre sections
of the front roll can be removed as follows:
1.
Unscrew the bolts and remove spindle and rolls.
2.
Insert split pins into the spindle, position
washers and outer rolls.
NOTE: Split pins and washers are supplied with
the machine.
3.
Reassemble.
en-44
A
B
Fig 8.12a
A
B
Fig 8.12b
Fig 8.13
Publicidad
Capítulos
Tabla de contenido
