Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Checking Blade Guard Functionality; Operation - Parkside PHKSA 20-Li A2 Manual Del Usuario

Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦ Allow the battery pack
handle.
Removing the battery pack
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see fig. A).
The charge status will be shown on the battery
display LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Checking blade guard functionality

♦ Pull the release lever for the blade guard
far as it will go.
The blade guard should move without jamming.
When letting go of the release lever for the blade
guard , it should automatically jump back to its
original position.
■ 10 │ GB │ IE
to click into the
and remove the
to
as

Operation

Fitting/changing the saw blade

Always remove the battery pack before changing
the saw blade !
1. Set the cutting depth (using the locking
screw ) to the minimum position, 0 mm.
2. Swing the blade guard
release lever and put the appliance down.
3. Press the spindle lock button
engages) and use the hex key
clamping screw . Now remove the clamping
screw and the clamping flange
fig. A).
Fig. A: Changing the saw blade
4. Remove the saw blade
5. Fitting a saw blade
reverse order.
6. Press the spindle lock button
and use the hex key
screw/washer .
WARNING!
► The arrow on the saw blade
spond to the arrow showing the direction of
rotation (running direction shown on the
blade guard ).
■ Ensure that the saw blade
rotational speed of the tool.
back using the
(until it
to release the
(see also
.
is carried out in the
(until it engages)
to tighten the clamping
must corre-
is suitable for the
PHKSA 20-Li A2