Stalgast 801350 Instrucciones De Uso página 30

4.4. Drain hole
The device is equipped with a drain pipe which should be installed at fl oor level with the use of siphon
Before starting the device, make sure that the supply pipe and the drain pipe were not bent, jammed or otherwise
damaged during installation.
4.5. The fi rst start-up
Before starting the machine, check the correct operation of the electrical protection system. The above steps and the
fi rst start-up of the device may only be performed by the employees of the technical service, who will also conduct a brief
training concerning the functioning of the device. Each device is equipped with an adjustable rinse aid dispenser. Meanwhile,
only select models of the device are equipped with a detergent dispenser with the possibility of adjustment. The detergent
and rinse aid containers should be placed in the proper location and then the suction tubes should be connected: the clear
tube to the detergent and the blue tube to the rinse aid. For adjustment, use the adjustment screws shown in fi g. 4. It is
recommended for the adjustment to be performed by the personnel of the company supplying the rinse aid and detergent.
Before connecting the suction tubes it is necessary to attach weights (in order to keep the tubes on the bottom of the
containers) and put on the fi lters ( fi g. 5).
Fig. 4
In the event the dispensers have not been installed before the installation of the device, it can be done at a later time using an
appropriate set of tools.
Alternatively, an external detergent dispenser may be connected through an electric connection using a 2x0,5mm
electric cable. The cable should be connected through the passage indicated on the technical data diagram, in accordance
with the electrical parameters of the device and the applicable legal provisions. Dispenser parameters: 230V/50Hz, 8W. The
detergent dispenser should be connected to the dishwasher using a clear tube.
5. HEALTH & SAFETY RULES
In order to prevent burns and electric shock please observe the following safety rules:
• training of staff in the use of the device in accordance with the information contained in this instruction manual
• training of the personnel in the scope of the basic principles of operation of electrical appliances, workplace safety and
provision of fi rst aid in case of need,
• before starting any maintenance work, disconnect the device from the power supply,
• it is prohibited to turn the device on, if any heating element and/or control element is damaged.
The manufacturer is not liable for any injuries or damage to the product resulting from failure to comply with the
recommendations contained in the instruction manual, improper use of the device, use of non-original spare parts and
attempts to repair the device independently.
• The device should be connected to an electrical grid with grounding in accordance with the applicable regulations and
standards.
• The device complies with the standards introduced under the European Union's Directives. The proper storage of the
device is an element of prevention of the pollution of the environment.
Do not add solvents such as alcohol or turpentine to the dishwasher as they can cause an explosion. It is also prohibited
to place dishes with remnants of food products in the dishwasher.
The dishwasher and its components should never be used as a ladder or as a support for other devices or items.
Fig. 5
- 30 -
H07 RN-F
2