Device Operation - Stalgast 801350 Instrucciones De Uso

Do not sit or lean against the open door of the dishwasher as that may lead to an accident. In order to avoid the above
situation, the doors of the device should always be closed.
The water remaining in the dishes after the completion of the cycle is not suitable for drinking.
The device may not be independently operated by minors or persons with limited intellectual, physical and sensory
abilities, who are not able to fully comply with the rules contained in this manual. The above mentioned persons may only
operate the device under supervision.

6. DEVICE OPERATION

6.1. Activities carried out before the start of washing
Only use detergents and rinse aids intended exclusively for industrial dishwashers. It is prohibited to use detergents intended
for manual dish washing. We recommend using detergents produced specifi cally for this dishwasher.
When fi lling the detergent containers, be careful not to accidentally activate the device, as this may cause damage
or failure of the device. It is prohibited to mix various detergents, as this may cause damage to the dispenser. Industrial
detergents may cause irritation. Therefore it is always necessary to follow the instructions provided on the detergent
packaging.
The valve
should be
The levels of detergent and rinse
opened
6.2. Loading of the dishwasher
1. Plates
The basket can hold 12 deep plates or 18 fl at plates. It is necessary to remove remnants of food from the surface of the
plates. Before washing plates with dried up remnants of cheese, eggs, etc., they should be left in cold water in order to soak
off.
Fig. 6
2. Glassware
It is necessary to remove any residue from glasses, wine glasses, etc., and place them in the basket with the bottom facing
up.
3. Cutlery
Use the basket to washing cutlery. It is recommended that cutlery is placed with the handles facing down. Knives and forks
must be handled with appropriate care (risk of injury).
Check:
aid in the containers
The correctness of
the fi lters placement,
the correctness of the
nozzle rotation, the
throughput of the device
(whether there are any
foreign bodies inside the
device which prevent
the correct operation of
the device).
Fig. 7
- 31 -
The main switch should be
turned off; the "OFF" sign will
appear on the display.