of water. In the event the device will no longer be used, after the completion of the above and the possible initiation of a
regeneration cycle, it is necessary to turn the device off by pressing the switch. The main switch should then be turned off
and the water valve should be closed.
7. PROBLEMS, CAUSES, SOLUTIONS
Note: If the activities for the removal of the faults described in the table below did not provide the desired result, please
contact the repair service (qualifi ed technical personnel).
PROBLEM
The device does not turn on
Washing process lasts too long
The device does not wash dishes
Spots on forks, glasses and vessels
Dishwasher does not rinse
Leaking solenoid valve
The water pressure in the device
is too low
The pump is not pumping out
water
CAUSE
The doors of the device are not
closed properly
Blown fuse
Improper connection to the
electrical network
Wash water temperature is not
correct
Incorrect water level in the chamber
of the device
Broken washing pump
Low pump pressure
Water temperature too low
Incorrect washing agent
Arms covered with lime scale or the
presence of foreign bodies
Empty detergent container
Faults in the water treatment device
Incorrect arrangement of the dishes
Rinse water temperature is too high
Incorrect water pressure
Water hardness level is too high
The detergent did not work, because
of dirty water in the device
Incorrect drying of the dishes
Incorrect rinse agent
Contaminated water inlet fi lter
Low water pressure
Broken rinse pump
Contamination of the solenoid valve
Contaminated water inlet or
solenoid valve fi lter
Low hardness of water in the water
network
Clogged pump
Faulty pump
- 36 -
SOLUTION
Open and then close the door again
Replace the fuse (call the service)
Check the connection to the electrical
network
Set the correct temperature
Clean the water inlet fi lter
Call the service
Clean the pump fi lter
Adjust the water heating time
Contact the manufacturer
Clean the arms and remove the foreign
bodies
Fill the container
Kontakt mit Service
Arrange the dishes in accordance with
the instructions
Set the correct temperature
Clean the fi lters
Check the water hardness
Change the water in the device
Change the water in the device
Contact the manufacturer
Clean the fi lter
Clean the pump fi lter and the solenoid
valve
Call the service
Call the service
Note: during the installation of the
device foreign bodies or unwanted
chemical compounds from the water
supply could have contaminated the
solenoid valve.
Clean the water inlet or solenoid valve
fi lter
Contact a plumber
Contact the service