2
1. Thrust rod
2. Higher
3. Lower
ENOW00043-0
WARNING
Do not put hand or finger in between
outboard motor body and clamp bracket
when adjusting trim angle to prevent
injury in case the outboard motor body
falls.
Unsuitable trim position can cause loss
of control of boat. When testing a trim
position, run boat slow initially to see if it
can be controlled safely.
All manuals and user guides at all-guides.com
ENOW00044-0
Excessive trim up or down may lead to
unstable boat operation, potentially caus-
ing the steering difficulty that leads to acci-
dent during cruising.
ENOF00053-0
ENOM00055-0
EFT, EPT type
The provided Power tilt makes tilt-up/
down electrically. It may be used as a
power trim and tilt when the outboard
motor is used with the light load condition.
In this case, it can be adjusted to set the
1
desired trim angle of the outboard motor in
3
relation to the transom shape, planning
ENOF00054-0
speeds and load. It is imperative that the
trim angle is adjusted correctly. Incorrect
adjustment will cause the boat to sway,
deteriorate engine performance and may
cause unsafe steering conditions.
ENOW00045-0
The Power Trim & Tilt can be set to any trim
angle, however, avoid cruising with the out-
board motor tilted in the tilt range. Operat-
ing the boat in this manner, the outboard
motor may ingest air into the water cooling
system, resulting in engine overheating.
ENOM00056-0
How to use the trim meter (option)
When the trim angle is set as desired, take
ENGINE OPERATION
WARNING
Do not cruise at high speed if improper
trim position is suspected. Stop the boat
and readjust trim angle before continu-
ing cruise.
For outboard motor model with PTT
switch on the bottom cowl, do not oper-
ate the switch during cruising, or control
of boat may be lost.
CAUTION
43