Command Devices; Pre-Start-Up Checks; Appliance Activation - Senco AC33024 Instrucciones De Empleo

18. COMMAND DEVICES

EN
The command devices are:
1 Electrical supply cable
Pressure switch
2
"ON-OFF" switch
3
4 Outlet pressure regulator
Air outlet spigot
5
6 Tank pressure gauge
Tank outlet gauge
7
2
1 7

19. PRE-START-UP CHECKS

BEFORE STARTING UP THE APPLIANCE, AUTHORISED
OPERATORS MUST CARRY OUT THE FOLLOWING
CHECKS.
• Ensure that no unauthorised persons are in close proximity
of the appliance.
• Ensure that safety devices are not damaged and that they are
correctly installed and operational (see Paragraph 13).
• Ensure that the appliance is correctly positioned (see
Paragraph 9).
• Ensure that the "ON-OFF" switch is in the "OFF (0) position
(see Paragraph 18).
• Ensure that the condensate pump is closed (5).
3 5
4
6
5
• Use the compulsory personal protection equipment (PPI)
(see Paragraph 15).
• Ensure that you have read and understood all parts of the
present "Instruction Manual".

20. APPLIANCE ACTIVATION

DANGER OF BURNS UPON ACCIDENTAL CONTACT
WITH THE TWIN CYLINDER PUMP SYSTEM AND
ELECTRIC MOTOR. WARNING – RESIDUAL RISK (SEE
PARAGRAPH 16).
THE MANUFACTURTER DECLINES ANY RESPONSIBILITY
FOR DAMAGE TO PERSONS, ANIMALS OR OBJECTS CAUSED
BY INOBSERVANCE OF REGULATIONS AND THEWARNINGS
DESCRIBED IN THE PRESENT MANUAL.
THE MANUFACTURTER DECLINES ANY RESPONSIBILITY FOR
THE OUTCOME FOLLOWING USAGE AS THIS IS DEPENDENT
ON THE UTENSIL USED AND THE PROFESSIONAL SKILLS OF
THE AUTHORISED OPERATORS.
THE AUTHORISED OPERATORS MAY ONLY START UP THE
APPLIANCE ONLY AFTER HAVING CARRIED OUT THE COMP-
LULSARY CHECKS DESCRIBED IN PARAGRAPH 19.
BEFORE USING THE APPLIANCE IN QUESTION, AUTHORISED
OPERATORS MUST READ AND UNDERSTAND ALL PARTS OF
THE PRESENT MANUAL.
DURING OPERATION, PLEASE ENSURE THAT UNAUTHOR-
ISED PERSONS DO NOT COME WITHIN PROXIMITY OF THE
APPLIANCE.
AUTHORISED OPERATORS MUST NOT LEAVE THE APPLI-
ANCE UNSUPERVISED WHILST IN OPERATION OR DURING
MAINTENNACE INTERVENTIONS.
2
1 7
1) Connect the appliance to the power supply (1) by plug-
ging it in.
2) Switch on the appliance using the "ON-OFF" switch (3)
ensuring it is in the "ON (I)" position (the appliance is opera-
tional until it reaches a maximum operating pressure of 10
bar, after which, it switches off automatically.
3)
Regulate the outlet pressure using the relevant regulator
(4) according to the utensil used and type of work. Control
the pressure displayed by the relevant gauge (6).
8
3 5
4
6