Metrohm 798 MPT Titrino Instrucciones De Uso página 119

798 MPT Titrino
C42: Time from start of titration to end in s, "62".
C43: Volume drift on start of a SET titration from the conditioning
in ul/min, "3.5".
C44: (Last measured) temperature in °C. Used for the temperature
compensation in pH measurements.
C45: Start volume with DET, MET, SET in ml, "2.800".
C46: Asymmetry pH of CAL, "6.89".
C47: Relative electrode slope of CAL, "0.9950".
C48: Voltage at maximum voltage (not valid in CAL and TIP)
C49: Voltage at minimum voltage (not valid in CAL and TIP)
DTime: Time in s for the drift correction in SET with conditioning.
3.2.2.97. Info.TitrResults.FixEP.51.Value
etc. up to .59
Info.TitrResults.pK.61.Value
etc. up to .69
Info.TitrResults.TempVar.C70
etc. up to .C79
.FixEP: Fix EP with DET, MET. C5X corresponds to X = 1...9.
.pK: With DET, MET. C6X corresponds to X = 1...9.
.TempVar: Temporary variables in TIP corresponding to the assignments in
the submethods.
3.2.2.98. Info.StatisticsVal.ActN
Info.Statistics.1.Mean
Info.Statistics.1.Std
Info.Statistics.1.RelStd
etc. up to .9
The current values of the statistics calculation.
$Q sends, e.g.
ActN: Current value of the individual results
Data for MN1:
Mean: Mean value (decimal places as in result)
Std: Standard deviation (1 decimal place more than in result)
RelStd: Relative standard deviation (in %, 2 decimal places)
3.2.2.99. Info.SiloCalc.C24.Name
Info.SiloCalc.C24.Value
Info.SiloCalc.C24.Unit
for .C25 as for .C24
Info.SiloCalc.C26.ActN
Info.SiloCalc.C26.Mean
Info.SiloCalc.C26.Std
Info.SiloCalc.C26.RelStd
for .C27 as for .C26
The current values from the silo calculations. C26 is the mean value out of the
C24 variables; C27 comes from C25.
$Q sends:
C24.Name: Name of the assigned value
C24.Value: Value
3.2 Remote control commands
read only/read+write
read only
read only
read only
read only
read only
read only
"3"
"3.421"
"0.0231"
"0.14"
read only
read only
read only
read only
read only
read only
read only
"RS1"
"2.222"
115