If the tire check shows that the pressure of the sealant-filled tire is less than 19 psi
CAUTION
(130 kPa, 1.3 bar) or if there are any cracks, bumps or similar tire damage visible,
you must not continue to use that tire.
18 If the inflation pressure of the sealant-filled tire is 19 psi (130 kPa, 1.3 bar) or more, it
must now be adjusted to the pressure specified for your vehicle (see vehicle placard).
19 Make sure that the compressor switch
20 Insert the power plug
21 Start the engine (only if the vehicle is outdoors or in a well ventilated area).
WARNING
It may cause asphyxiation if the engine is allowed to run in a non-ventilated or poorly
ventilated area (e.g. inside a building)!
22 Switch the orange switch
cified tire pressure.
23 Switch the compressor off and check the tire pressure again. If tire pressure is too high,
deflate the tire to the specified pressure using the pressure relief valve
24 Once you have inflated the tire to its correct pressure, switch off the compressor, pull
the plug out of the socket, unscrew the hose, fasten the valve cap and store the
ContiComfortKit away safely in the vehicle trunk.
After using the sealant you may drive no faster than 50 mph (80 km/h), and the
WARNING
damaged tire must be replaced as quickly as possible (within a maximum driving
distance of 125 miles (200 km)). You must not continue to drive if heavy vibrations,
unsteady steering behavior or noises should occur while driving.
25 Drive to the nearest tire dealer to get the damaged tire replaced. Before the tire is
removed from the rim, inform your tire dealer that the tire contains sealant (see separa-
te tire demounting instructions). Both the hose and the canister of sealant need to be
replaced after using the ContiComfortKit. Information on how to replace these parts is
given on page 22.
Attention!
Remember that emergency roadside tire repair kits only provide temporary mobility.
Regulation concerning tire repair after usage of ContiComfortKit may differ from country to country.
You should consult a tire dealer for advice.
Before driving, ensure tire is adjusted to recommended inflation pressure as indicated
WARNING
on vehicle placard. Monitor tire pressure until sealed tire is replaced. Proceed as
described above from point 15 onwards.
All manuals and user guides at all-guides.com
g
is switched off to "0".
h
into the cigarette lighter socket.
g
on the compressor to "I" and pump the tire up to the spe-
GB
US
D
F
I
E
i
.
5