To Empty The Debris Hopper; Towing Instructions - Nilfisk-Advance 7765 Serie Instrucciones De Uso

POST-OPERATION & CLEAN-UP INSTRUCTIONS
TO EMPTY DEBRIS HOPPER
1. Transport or sweep and scrub to the dump site.
2. Close the hopper dump door with the hopper dump lever.
3. Raise the hopper with the hopper lift lever to the desired level.
4. Move the machine forward, over the dumpster, if necessary.
5. Open the hopper dump door with the hopper dump lever.
6. Lower the hopper with the hopper lift lever to the normal operation position.
The sweep functions - main broom, side broom, dust fan, and fi lter shakers - only work when the hopper is down and the dump door is
TOWING INSTRUCTIONS (SEE FIGURE 21)
1. Locate Tow Control shaft Extension (AN) as shown in Figure 21. (See arrow)
2. To open hydraulic circuit to wheel drive motor, turn shaft 90° so that the fl ats on the shaft are parallel to the front axle.
3. After towing, turn shaft 90° so that the fl ats on the shaft are parallel to the pump centerline.
NOTE (Variable Dump Only)
open.
ENGLISH / A-25
FORM NO. - 56041801 - 7765 - A-25