A-20 / ENGLISH
OPERATING INSTRUCTIONS
FILLING THE SOLUTION TANK
NON-RECYCLING OR STANDARD SCRUBBING SYSTEM
1.
Make sure the solution control lever is in the "Off" (rear) position.
2.
Open the solution tank cover (right hand side).
3.
Fill the tank with 100 gallons (378 L) of water and the correct mixture of Advance #100 Industrial Cleaner for the job.
4.
Close the solution tank cover.
RECYCLING OR ESP SYSTEM
1.
Make sure the solution control lever is in the "Off" (rear) position.
2.
Open the solution tank cover (right hand side).
3.
Fill the solution tank as outlined above with 100 gallons (378 L) of pure water.
4.
Fill the detergent tank with 5 gallons (19 L) of Advance #100 Industrial Cleaner.
5.
Close the solution tank cover.
PRE-START CHECKLIST
1.
Clean engine air fi lter element if needed
2.
Check engine oil level
3.
Check radiator coolant level
4.
Check hydraulic fl uid level
5.
Check fuel level
6.
Check all systems for leaks
7.
Check brakes and controls for proper operation
BEFORE STARTING ENGINE
1.
Set parking brake
2.
Make sure all controls are in the "Off" position
TO START ENGINE
1.
Be sure accelerator and directional control pedal is in neutral.
2.
Turn key to "On" position and hold it until the engine starts.
3.
If engine fails to start after following the above procedures, refer to Engine Manual.
The manufacturer does not advise storing the machine in below-freezing temperatures unless all fl uids have been drained from the
detergent, solution and recovery tanks and associated systems. When machine has been stored in below-freezing temperatures, run
engine at lowest possible settings and let machine sit 5-10 minutes to warm engine and hydraulic oil.
A-20 - FORM NO. - 56041801 - 7765
NOTE
Fill recovery tank halfway with water for the ESP system
WARNING
To prevent over-sudsing and machine damage,
use only ADVANCE Industrial Cleaning Solution #100.
WARNING
DO NOT put gasoline, combustible or other fl ammable material
in the solution, recovery or detergent tanks.
NOTE
Before starting the engine, perform the pre-start checklist.
WARNING