Assembly; Remove The Generator From The Shipping Carton; Install The Wheel Kit; Install The Support Leg - ETQ PG30P11 Manual De Usuario

ETQ
EASTERN TOOLS & EQUIPMENT INC

Assembly

Your generator requires some assembly.
This unit ships from our factory without oil.
It must be properly serviced with fuel and oil before
operation.
If you have any questions regarding the assembly
of your generator, call our help line at
1-888-696-2345.Please have your serial number
and model number available.
Remove the Generator from the
Shipping Carton
1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the
generator.
3. Carefully cut each corner of the box from top to
bottom. Fold each side flat on the ground to provide
a surface area to install the wheel kit and support
leg.

Install the Wheel Kit

The wheel kit is not intended for over-the-road
use.
You will need the following tools to install the
wheels:
12 mm wrench
Socket wrench with a 12 mm socket Pliers
1. Before adding oil to the engine, tip the generator
slowly so that the engine side is up.
2. Attach the axle to the bottom of the frame with
four mounting bolts and nuts.
3. Slide a wheel onto the axle.
4. Place a washer on the end.
5. Install the cotter pin through the hole on the end
of the axle.
6. Carefully bend the legs of the cotter pin back
around the axle.
7. Repeat steps 3-6 to attach the second wheel.
Tel: (888)696-2345

Install the Support Leg

1. Attach the rubber vibration mount to the support
leg with a cap screw (M8x20) and lock nut (M8).
2. Attach the support leg to the generator frame with
cap screws (M8x30) and lock nuts (M8).
3. Tip the generator slowly so that it rests on the
wheels and support leg.

Install the Handle

1. Place the handle over the mounting channel on
the frame.
2. Secure the handle to the frame using the two
handle bolts.
3. Place a lock nut (M8) on the end of each bolt and
fasten securely. DO NOT over tighten the lock nuts.

Install the Spark Arrester (optional)

Insert the spark arrester screen into the muffler
outlet. Secure the spark arrester by placing the
cover plate over the end of the screen, with the
lettering facing outward.
Secure the cover plate with the two screws and lock
washers provided with the spark arrester kit.

Add Engine Oil

DO NOT attempt to crank or start the engine before
it has been properly filled with the recommended
amount of oil. Damage to the generator as a result
of failure to follow these instructions will void your
warranty.
1. Place the generator on a flat, level surface.
2. Remove oil fill cap/dipstick to add oil.
3. Add 0.63 qt (0.6 L) of oil and replace oil fill
cap/dipstick.
4. Check engine oil level daily and add as needed.
Web Site: easterntools.com