ETQ PG30P11 Manual De Usuario página 9

ETQ
EASTERN TOOLS & EQUIPMENT INC
Operation instruction of REDUCTOR ASSY
(5)
NO. DESCRIPTION
1 High-pressure intake tube(1000mm)
2 REDUCTOR ASSY
3 TANK TOP COMP,FUEL
4 Low-pressure outlet tube
Instruction on LPG denser device (bottom)
To develop cold start performance of LPG generator unit, the air REDUCTOR ASSY includes one LPG denser device
(bottom), the detailed operation of the bottom is shown below.
When starting the cold LPG generator unit, open the valve of the LPG tank, close the resistance air valve handle, press
the LPG denser device (bottom) lightly, and hold for 1-2 seconds, then stop. Start the engine normally, and after
finishing the start up, please open resistance air valve handle.
(1)
IN
OUT
(4)
1.The bottom only works after turning on the LPG tank
vvalve, if started normally, there is no need to press the
bbottom device, or it will cause the generator unit to work
aabnormally.
2.When pressing the bottom, the time must not be over
2 2 seconds, otherwise it may not start;
3.There is no need to press the bottom at every start.
Only when there is a need for a cold start or when the
g gas is changed.
4.If there are abnormalities, please contact us at
1-888-696-2345;
5.Prohibit adjusting the regulation bottom.
Tel: (888)696-2345
(2) (6)
(7)
(3)
Qty NO.
1 5 Mix device( the same as carburetor)
LPG denser device (bottom)→mounted
1 6
onto REDUCTOR valve
LPG air-pressure adjusting bottom →
1 7
mounted onto REDUCTOR valve
1
Web Site: easterntools.com
DESCRIPTION Qty
1
1
1