Maintenance; Engine Maintenance; Oil; Spark Plugs - ETQ PG30P11 Manual De Usuario

3500 vatios máximos/3000 vatios de funcionamiento, distorsión armónica total t.h.d5
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ETQ
EASTERN TOOLS & EQUIPMENT INC

Maintenance

The owner/operator is responsible for all periodic
maintenance.
Never operate a damaged or defective generator.
Tampering with the factory set governor will void
your warranty.
Improper maintenance will void your warranty.
Complete all scheduled maintenance in a timely
manner. Correct any issue before operating the
generator.
?
NOTE
For service or parts assistance, contact our
help line at 1-888-696-2345.

Engine Maintenance

To prevent accidental starting, remove and ground
spark plug wire before performing any service.

Oil

Change oil when the engine is warm. Refer to the oil
specification to select the proper grade of oil for your
operating environment.
1. Remove the oil drain plug with a 15 mm socket
and extension.
2. Allow the oil to drain completely.
3. Replace the drain plug.
4. Remove oil fill cap/dipstick to add oil.
5. Add 0.63 qt (0.6 L) of oil and replace oil fill
cap/dipstick.
Tel: (888)696-2345
6. Dispose of used oil at an approved waste
management facility.

Spark Plugs

1. Remove the spark plug cable from the spark plug.
2.Use the spark plug tool that shipped with your
generator to remove the plug.
3. Inspect the electrode on the plug. It must be clean
and not worn to produce the spark required for
ignition.
4. Make certain the spark plug gap is 0.7 - 0.8mm
(0.028 - 0.031 in.).
5. Refer to the spark plug recommendation chart
when replacing the plug.
6. Carefully thread the plug into the engine.
7. Use the spark plug tool to firmly install the plug.
8. Attach the spark plug wire to the plug.

Air Filter

1. Remove the snap-on cover holding the air filter to
the assembly.
2. Remove the foam element.
3. Wash in liquid detergent and water.
Squeeze thoroughly dry in a clean cloth.
4. Saturate in clean engine oil.
5. Squeeze in a clean, absorbent cloth to remove all
excess oil.
6. Place the filter in the assembly.
7. Reattach the air filter cover and snap in place.
Web Site: easterntools.com

Publicidad

Tabla de contenido
loading

Tabla de contenido