Tsc Probe Calibration; Visualize Brand; Ids Presence; Software Version - Rancilio classe 10 SDE Manual Para El Técnico

4.2.16 TSC probe calibration

This programme is used to align the TSC system
temperature sensor with the reference value using
software.
The display shows the temperature measured by the
sensor and the one that must be aligned.
Check that the temperature read with a reference
thermometer equals the one read by the sensor.
If the thermometer shows a higher or lower tempera-
ture, make the changes using the "+" or "-" buttons in
order to align the control system of the temperature.
Then, press "enter" to confirm.
4.2.17 Maintenance setting
This menu allows you to set when to schedule main-
tenance on a time and cycle basis. This means that
the machine will warn you when it is time to carry out
the preventive maintenance.
Reset the counters after completing the maintenance.
4.2.18 Errors file
Displays the malfunctions or the warnings of the
intervention of the safety devices stored by date
and time.
4.2.19

Visualize brand

This menu allows you to enable or disable the display
of the personalizable logos.
4.2.20 IDS Presence (Interface Data System)
Press the "+" or "-" buttons to open the submenu and
enable or disable data unloading.
disable
enable
Rancilio data unloading board can communicate
with data storage systems or with computer through
RS232 interface or parallel interface.
CAUTION: if the function is enabled without
the data unloading board, a machine
mulfunction will occur.
4.2.21

Software version

Version number and date of release displayed
All manuals and user guides at all-guides.com
5.

DISPLAYING

A high performance graphical display is used. It has
many features.
5.1.

Warming Up Phase

During the warming up phase, the following message
is displayed:
"Machine "not ready" "
MACHINE "NOT READY"
Until the set pressure is reached.
The following messages are also displayed, con-
cerning:
"Please make the regenerate softener", if the
function is enabled and the set values have been
reached (this message will be then repeated every
PLEASE MAKE THE
REGENERATE
SOFTENER
"Please make the service time", if the function is
enabled and the set values have been reached (this
message will be then repeated every hour until it is
reset)
PLEASE MAKE THE
SERVICE TIME
49