2Nd Time; Reception Indicator - Junghaus J615.96 Manual Del Usuario

If the time zone has been adjusted by more than one hour, it is not possible
to display the calendar week. Instead of the calendar week the last two digits
of the year are displayed.
Following a restart, the watch automatically resets to the German language
for reception in Europe (reception of DCF77), and to the English language for
reception in USA or Japan.

4.3 2nd time

T2
T1
Adjustment of the 2nd time is done in steps of 15 minutes via the buttons T3
"+" or T5 "–" respectively.
To confirm, please press button T2 "SET". If a button is not pressed within
approx. 9 seconds the setting will be automatically confirmed.
52
All manuals and user guides at all-guides.com
The 2nd time provides you display a
further time in the LC display, which is
independent from the analogue time
(for example, if you are on holiday in
T3
another time zone and wish to see the
time at home).
Press the T1 "MODE" button repeatedly
until you reach the "2nd time = T2"
T5
mode. By pressing the T2 "SET" button
> 3 seconds the function is released
(hours and minutes in LC display start
to flash).

4.4 Reception indicator

T1
Press the T1 "MODE" button repeatedly until you reach the reception indica-
tor mode. The code for the transmitter will appear in the upper part of the LC
display, a number is displayed in the lower part, the reception indicator.
If the reception indicator shows "0", the watch has picked up the signal pro-
perly during overnight synchronisation. The numbers "1-9" show for how
many days the watch has been unable to synchronise automatically due to
bad reception conditions. After the next successful synchronisation the indi-
cator reverts back to "0".
In the reception indicator mode you
recognise whether your watch has been
synchronised with the signals of a trans-
mitter.
The following transmitter displays are
possible:
DCF 77,5 kHz
WWVB 60 kHz
JJY 40/60 kHz
53