Installation; Transport And Handling - battioni Pagani REVOBLOCK 7 Manual De Instrucciones De Uso Y Mantenimiento

REVOBLOCK motorised joint
use and maintenance manual

4.1 - TRANSPORT AND HANDLING

When handling the machine it is necessary to use appropriate lifting equipment.
This lifting equipment must
be suitable, based on capacity, for the machine being handled.
As for dimensions and mass of the machine to be lifted, refer to technical data.
In order to locate the correct lifting points, refer to the figure below
HOOKS
Make sure that vehicles and logistic structures used conform to the required use and are in
perfect conditions.
Keep at a distance from suspended loads. During the operation use work gloves, safety
shoes and safety helmet.

4.2 - INSTALLATION

For installation, follow the phases shown below:
- refer to 4.1 - TRANSPORT AND HANDLING when lifting the machine and bring it to the installation position.
- fasten the bolts of the connection flange.
The joint was designed to be installed both with a vertical and a horizontal rotational axis, it is indifferent.
pag. 44
4 - INSTALLATION
When unloading from the transport vehicle, proceed slowly in
order not to damage other component parts.
Each phase that is not completed correctly may damage the
component or create dangerous situations for operators.
It is recommended to use personnel that has been given this
specific task and is appropriate for using lifting equipment and
make sure that they are knowledgeable about the following
instructions.
FLANGE