GYS GYSPRESS 10T PP Manual Del Usuario página 36

If Flow-Form rivets are used, the metal sheets must be drilled beforehand to allow the rivet to be fitted. The aforemen-
tioned header die and die allow precise drilling as well as the calibration of Flow-Form rivet holes.
After punching, the header die is driven into the sheets metal.
The header die is removed and the sheet metal is prepared for
riveting.
If the punch does not come out of the sheet metal, use the
riveter's PULL function.
Press the PULL button and pull the trigger.
Once the header die is out of the sheet, press the PUSH button.
SETTING UP FLOW-FORM RIVETS
Once the pilot hole has been made, insert the Flow-Form
36
WORKSTATION GYSPRESS 10T PP CONTROL
Before trying to assemble sheets using Flow-Form rivets, a pilot hole must first be created (see
process above).
rivet into it:
The F1 tip should be placed on the top of the rivet:
EN