Tabla de contenido
Publicidad
8-12
Replacing the Paddle Assy
The paddle assy weighs approx. 25kg. Ensure that at least two (2) people
are available to remove or install the assy, and that there is sufficient
space to work safely.
1.
Remove the paddle vac-form covers.
2.
Remove the left and right paddle blades.
3.
Remove the left and right paddle bellows.
4.
Remove four (4) security screws (M5x12). Remove the rear plate on the
coin tower and disconnect the connector.
5.
Remove the seven (7) hex head set screws, and remove the paddle assy.
6.
When replacing the paddle assy, fit finger tight, the two screws (1) above,
and check that the assy is central.
Fit, finger tight, one screw (2) above, and then the remaining four screws.
Tighten all seven screws fully.
(see section 8-7 page 66)
(See section 5-4 page 44)
(see section 8-10 page 69)
Page 71
Publicidad
Tabla de contenido
