Fulcrum SPEED 40T Manual Del Usuario página 17

®
• The wheel you have purchased is designed to use tubular tires.
• Check to insure that the diameter and cross-section of the tubular tire you
plan to use are compatible with the dimension of the rim.
• The first time the tubular tyre is applied sand the rim with 120 grain
sandpaper in order to eliminate the surface polish and lubricate the rim
gluing surface with acetone before applying the glue for the tubular tyre.
We recommend using at least 2 coats of glue on the rim and one on the
tyre and leaving the glue to dry at least 12 hours between one gluing and
the next. Wait at least 24 hours after gluing the tubular tyre before using
the wheel.
• Ensure that, when high pressure is applied by hand on the tubular tyre, it
does not detach from the wheel.
• To remove the tubular tyre from the rim, unglue the tubular tyre in an area
sufficient to insert a screwdriver between the rim and the tubular tyre; mo-
ving the screwdriver along the rim, unglue the tubular tyre (Fig.1).
- Do not remove the tubular tyre tearing it from the rim (Fig. 1.1).
• In order to ensure correct installation of the tubular tyre, check the tyre manufacturer mounting instructions as well.
WARNING!
• Because of the high temperatures reached when breaking, we recommend you use only glue for tubular tires specifically for carbon fibre rims.
• Incorrect mounting of the tyre may cause it to deflate, burst or detach suddenly and cause accidents, physical injuries or even death.
• Do not carry out any operation that may create scratches or cuts on the rim or which, in any way whatsoever, may damage it. A damaged rim can
break suddenly and cause accidents, physical injuries or even death.
4
2 - TIRES
OK!
1
NO!
1.1