Fulcrum SPEED 40T Manual Del Usuario página 20

4.2 - 11s SPROCKETS of Campagnolo s.r.l
1) The sprockets are pre-assembled and timed on
the plastic support (A - Fig. 2). The ring G (Fig. 2)
is provided with a preassembled washer (H); ensure
that it is positioned as in fig. 2.
2) Remove the ring (G - Fig. 2).
3) Insert the support on the side of the freewheel
body, align the spline patterns, press the sprockets
onto the freewheel and extract the support (A) from
the hub (Fig. 2).
4) If installing the sprockets without the plastic
support, install the individual or preassembled
sprockets and the spacers on the sprocket body
of the hub aligning the spline patterns (Fig. 3). The
profile of the freewheel body with two asymmetrical
grooves (Fig. 3) ensures automatic sprocket timing
since there is only one assembly option.
5) Using a torque wrench (D - Fig. 4) together
with the Campagnolo tool UT-BB080 (B - Fig. 4),
®
tighten the ring nut (G - Fig. 4) that came with the
Campagnolo sprocket pack onto the freewheel
®
body, observing the tightening torque indicated on
the instruction sheet of the sprocket pack.
. (on FW body for 11s sprockets of Campagnolo s.r.l.)
4.2.1 - ASSEMBLY
A
A
2
3
G
G
H
C
G
UT -BB080 UT-BB080
B
B
CLOSE
4
®
D
D
40 N.m - 29.5 lb.ft
7