Fulcrum SPEED 40T Manual Del Usuario página 19

®
• To inflate the tire: remove the cap, unscrew the valve and inflate using a pump with a pressure gauge to obtain the required pressure, then tighten the
valve and re-fit the cap.
• To deflate the tire: remove the cap, slightly unscrew the valve, then press it until the required pressure is obtained; tighten the valve and re-fit the cap.
WARNING!
• Never exceed the maximum inflation pressure recommended by the tire manufacturer.
Excessive tire pressure reduces the grip of the tire on the road and increases the risk that the tire will unexpectedly burst.
Inflation pressure that is too low reduces tire performance and increases the probability of sudden and unexpected loss of tire pressure. In addition,
premature wear and damage to the rim may occur.
• Incorrect tire pressure could cause tire failure or loss of control of the bicycle, resulting in an accident, personal injury or death.
Note
The tire pressure should also be adjusted depending on the weight of the rider; a heavy rider should have a greater tire pressure than a light rider.
3 - FITTING THE WHEEL ON THE FRAME / USING THE QUICK RELEASE
See the "Quick Release" instruction sheet.
4.1 - 9S / 10S SPROCKETS OF CAMPAGNOLO S.R.L. (ON FW BODY FOR 9S / 10S SPROCKETS OF CAMPAGNOLO S.R.L.)
Refer to the instruction leaflet enclosed with the sprockets for all the assembly, disassembly, use and maintenance operations.
6
2.2 - INFLATING AND DEFLATING THE TIRE
4 - SPROCKET ASSEMBLY AND REMOVAL