BFT DEIMOS BT Instrucciones De Uso página 22

ENGLISH
20) AUTOMATION OPERATION
Since the automation can be remote-controlled by means of a remote control
device or a start button, and so out of sight, the good working order of all
the safety devices should be checked regularly. In the event of any anomalous
functioningofthesafetydevices,consultaspecialisedtechnicianimmediately.Keep
children at a safe distance from the automation operation area.
21) CONTROL
The automation is used for the power-operated opening and closing of the
gate. The control can be of a number of types (manual, remote-controlled,
magnetic badge access control, etc.) depending on requirements and the
characteristics of the installation. See the specific instructions for the vari-
ous control systems. Users of the automation must be instructed about its
control and operation.
22) MAINTENANCE
Disconnect the power supply when carrying out any maintenance operations.
• Clean the lenses of the photocells every so often.
• Have a qualified person (installer) check correct motor torque setting.
• In the event of any anomalous functioning which cannot be resolved,
disconnect the power supply and contact a specialised technician (in-
staller). Whilst the automation is out of order, activate the manual release
to allow manual opening and closing.
23) BATTERY REMOVAL
When removing the batteries, observe the current regulations and in
particular:
1) Remove the batteries before dismantling the operator.
2) The batteries must be discarded safely.
3) The appliance must be disconnected from the
battery removal.
24) SCRAPPING
WARNING! This operation should only be carried out by qualified personnel.
Materials must be disposed of in conformity with the current regulations.
In case of scrapping, the automation devices do not entail any particular risks
or danger. In case of materials to be recycled, these should be sorted out by
type (electrical components, copper, aluminium, plastic etc.).
25) DISMANTLING
WARNING! This operation should only be carried out by qualified personnel.
When the automation system is disassembled to be reassembled on another
site, proceed as follows:
• Disconnect the power supply and the entire external electrical installation.
• In the case where some of the components cannot be removed or are
damaged, they must be replaced.
WARNINGS
Correct controller operation is only ensured when the data contained in the
present manual are observed.The company is not to be held responsible
for any damage resulting from failure to observe the installation
standards and the instructions contained in the present manual.
22 -
DEIMOS BT-MA Ver. 11
INSTALLATION MANUAL
power supply during