Starting Pull Start Engines - Generac GP Serie El Manual Del Propietario

Operation
not use premium gasoline. Do not mix oil with gasoline.
of screen filter. Be careful not to overfill (Figure 11).
IMPORTANT: It is important to prevent gum deposits from forming
in fuel system parts such as the carburetor, fuel hose or tank
during storage. Alcohol-blended fuels (called gasohol, ethanol
or methanol) can attract moisture, which leads to separation and
formation of acids during storage. Acidic gas can damage the fuel
system of an engine while in storage. To avoid engine problems,
the fuel system should be emptied before storage of 30 days or
longer. See the "Storage" section. Never use engine or carburetor
cleaner products in the fuel tank as permanent damage may occur.
Figure 11 - Fuel Tank

2.8 STARTING PULL START ENGINES

Never start or stop engine with electrical
devices plugged into the receptacles AND
devices turned on.
starting the engine.
any direction).
14).
until increased resistance is felt. Pull rapidly up and away.
until engine runs smoothly and then fully into RUN position. If
engine falters, move choke back out to 1/2-CHOKE position
until engine runs smoothly and then to RUN position.
If engine fires, but does not continue to run, move choke lever
to FULL CHOKE and repeat starting instructions.
10
NOTE:
Figure 12 - Fuel Shut-off Valve
Figure 13 - Engine ON/OFF Switch
Figure 14 - Choke Position
CHOKE LEVER
LEFT = CHOKE (START)
RIGHT = RUN