Troubleshooting - Rowenta IS63 Serie Manual De Instrucciones

TROUBLESHOOTING

Problems
There is no steam.
The steam flow is low. Your steamer has a build-
Water runs through
the holes of the steam
head.
The steamer takes a
long time to heat
and/or ejects white
particles.
The Roll & Press
system shade is
crooked.
The Roll & Press
system shade rolled
back up while in use.
The hose makes a
gurgling noise.
Water is overflowing
from water tank.
If it is not possible to establish the cause of the problem, seek the
assistance of an approved ROWENTA Service Center www.rowenta.com
Possible causes
The appliance has not
been turned on.
The hose has been
obstructed.
There is no water left in
the water tank.
up of scale because it has
not been rinsed out
regularly.
The hose has been
obstructed.
There is condensation in
the hose.
Your steamer has a build-
up of scale because it has
not been descaled
regularly.
The shade didn't roll back
correctly.
The shade was not locked
correctly in the hook.
You are using the steam
head in a position close
to the ground and some
condensation occurs in
the hose.
You are using the steam
head in a position close
to the ground and some
condensation occurs in
the hose.
Check that the device has been plugged in
correctly. Next press the On/Off pedal, the
power indicator light located at the front of
the device will come on.
The device will begin producing steam
after approximately 60 seconds.
Check that the hose is not bent or twisted.
Switch off the device and fill the water
tank.
See descaling process (Cleaning
paragraph).
Check that the hose is not bent or twisted.
Never use a steamer in the horizontal
position. Hold the hose vertically
outstretched and wait for the condensed
water to return to the steamer.
See descaling process (Cleaning
paragraph).
Unroll the shade again and keep your
hand on the handle while rolling back to
the top.
Make sure the Roll & Press handle is
firmly locked in the hook. It should not be
moving horizontally or vertically.
Raise the hose frequently during
use and adjust the pole to its
maximum height in order to avoid
the formation of condensation.
Raise the hose frequently during
use and adjust the pole to its
maximum height in order to avoid
the formation of condensation.
10
Solutions