Zoeller 1450-0009 Manual Del Usuario página 3

WARNING
ELECTRICAL SHOCK ALERT
Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and the
Occupational Safety and Health Act (OSHA).
ELECTRICAL SHOCK ALERT
All electrical wiring or service should be done by a qualified electrician.
EXPLOSION ALERT
Do not use to pump flammable or explosive fluids such as gasoline, fuel oil, kerosene, etc. Do not use
in flammable and/or explosive atmospheres.
HAZARDOUS PRESSURE ALERT
Install pressure relief valve in discharge pipe. Release all pressure on system before working on any
component.
CHEMICAL ALERT.
Prop65 Warning for California residents:
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
CAUTION
ELECTRICAL SHOCK MAY OCCUR
Wire motor for correct voltage. See Electrical section and motor nameplate.
ELECTRICAL SHOCK MAY OCCUR
Ground motor and controls before connecting to power supply.
ELECTRICAL SHOCK MAY OCCUR
Follow wiring instructions in this manual when connecting to power lines.
ELECTRICAL SHOCK MAY OCCUR
Protect power cable from nicks or cuts from sharp objects or scraping on well casing when lowering
pump into well. Do not allow it to come into contact with oil, grease, hot surfaces or chemicals.
ELECTRICAL SHOCK MAY OCCUR
The motor voltage and phase indicated on the motor nameplate should be checked against the actual
electrical supply. Check your power source. Check electrical supply for correct fusing, wire size, and
adequate grounding and transformer size.
PRODUCT DAMAGE MAY OCCUR
The power supply for a submersible pump should be a separate circuit, independent of all other
circuits. It must be equipped with a fuse box of ample capacity.
PRODUCT DAMAGE MAY OCCUR
Shut off power source when voltage drops 10% below rated voltage of motor.
FIRE SAFETY
For fire protection, power supply should be free of any building, preferably on a direct line from
transformer. In event of fire, wires will not be destroyed and water supply not cut-off.
NOTE: Install all electrical equipment in protected area to provide adequate ventilation for pressure
switch and controls to prevent moisture damage to components.
NOTE: Install pump, pressure tank, pitless adaptor or well seal in accordance with state and local
plumbing codes.
3