Zoeller 1450-0009 Manual Del Usuario página 8

4. Typical installations include the following
components. Purchase these items
separately depending on your need. (Fig. 4)
Discharge pipe - delivers water to home
Well seal or pitless adapter - keeps debris out
of well
Safety rope - prevents pump from falling
Check valve - keeps water in pipe
Electrical cable - connects to house electricity
Torque arrestor - keeps pump stable
Drop pipe - connects pump to discharge
Well casing - holds all components
ELECTRICAL HOOKUP AT THE PUMP
Submersible Cable Splicing
Pump is equipped with a lead wire assembly with three wires plus the green ground wire. The
length of wire needed to attach to this lead wire assembly is equal to the distance from the pump
in the well to the top of the well. Additional wire will be needed to run from the top of the well to the
house.
CAUTION: Follow instructions carefully to make a watertight splice. A leak in the splice can result
in pump damage, blown fuses, overload protector tripping or electric shock hazard.
Splicing instructions
1. Slide one black shrink tube from a heat
shrink splice kit (sold separately) over each
wire (including the green ground wire)
coming out of the pump. (Fig 1)
Discharge Pipe
4
Well Seal or Pitless Adapter
Safety Rope
Spring-Loaded Check Valve
(Recommended every 100 ft.)
Electrical Cable (Secured to drop
pipe with tape or clamps every
10 ft.)
Torque Arrestor
Drop Pipe
Well Casing
1
8
Shrink tube