ASSEMBLY INSTRUCTIONS
7. Assemble the reflector panel (A) onto the
flame screen (B):
WARNING: Be sure to remove the protective
film from the reflector panel (A) before
assembly.
Screw the three reflector spacers (CC) on
the flame screen (B). Put three washers Φ6
(BB) onto the top of the reflector spacers
(CC). Then put the reflector panel (A) onto
the reflector spacers (CC), securing them
with three washers Φ6 (BB) and three M8
wing nuts (AA).
Hardware Used
M8 Wing nut
AA
BB
Washer Φ6
Reflector
CC
spacer
8. Carefully install the glass tube (C) by lifting
it up and inserting it through the center hole
in the flame screen (B). Ensure the black
silicone ring (F) is attached to the lower
edge of the glass tube (C) as illustrated.
Slide the glass tube (C) through the hole of
the lower plate cover and onto the middle
plate on the control box assembly (I).
Check and ensure that the glass tube (C)
is positioned properly and is completely
covering the center hole of the middle plate
on the control box assembly (I).
WARNING! The black
silicone ring must be in place
prior to operating the heater.
7
AA
BB
A
CC
B
x 3
x 6
x 3
8
I
10
B
C
F
BLACK SILICONE
RING