Sanus VML5 Manual Del Usario página 14

4. Place the wall plate template
10
template and tape in place.
CAUTION:
Avoid potential personal injury or property damage! You MUST install using the center holes in the stud as shown
IMPORTANT
: Be sure you mark and drill into the center of the stud.
5. Drill the middle two pilot holes (into the stud) using a 7/32 in. (5.5 mm) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 3 in. (75 mm).
4
14
10
at your desired height and position the MIDDLE HOLES over your stud center lines. Level the wall plate
12
10
5
3 in. (75 mm)
7/32 in.
(5.5 mm)
10