Sears Kenmore 795.7032 Serie Manual De Uso Y Cuidado página 12

NOTE: Removing the doors is always recommended when it is necessary to move the refrigerator through a narrow
opening, if it is necessary to remove the handles, follow the directions below.
HOW TO REMOVE FREEZER DOOR HANDLE
NOTE: Handle appearance may vary from illustrations on
this page.
Removing Freezer Drawer Handle
Loosen the set screws located on the lower side of
the handle with a 1/8 in. Alien wrench and remove the
handle.
NOTE: If the handle mounting fasteners need to be
tightened or removed, use a 1/4 in. Alien wrench.
HOW TO REPLACE FREEZER DOOR HANDLE
NOTE: Handle appearance may vary from illustrations on
this page.
Replacing Freezer Drawer Handle
Place the handle on the door by fitting the handle
footprints over the mounting fasteners and tightening
the set screws with a 1/8 in. Alien wrench.
NOTE: If the handle mounting fasteners need to be
tightened or removed, use a 1/4 in. Alien wrench.
When taking apart or assembling the refrigerator or
freezer handle:
Grasp the handle tightly to avoid dropping it.
Dropping the handle could cause personal injury or
damage to the floor or handle.
Do not swing the handle towards people or animals
after taking apart the handle.
insert the bracket hole of the handle into the stopper
bolt of the door exactly, and then assemble the set
screws to fix the handle.
• Check if there's any gap between the door and
handle after fixing the handle.
12