Using Your Refrigerator; Setting The Controls - Sears Kenmore 795.7032 Serie Manual De Uso Y Cuidado

SETTING THE CONTROLS
AIRFLOW
The refrigerator control functions as the thermostat for the
entire appliance (refrigerator and freezer sections). The
colder the setting, the longer the compressor will run to
keep the temperature colder. The freezer control adjusts
the cold air flow from the freezer to the refrigerator.
Setting the freezer control to a lower temperature keeps
more cold air in the freezer compartment to make it
colder.
Cold air circulates from the freezer to the fresh food
section and back again through air vents in the walt
dividing the two sections. Be sure not to block vents while
packing your refrigerator. Doing so will restrict airflow
and may cause the refrigerator temperature to become
too warm or cause interior moisture buildup. (See air flow
diagram below.)
Temperature
NOTE: When changing control settings, wait 24 hours
before making additional adjustments. The controls are set
correctly when milk or juice is as cold as you would like
and when ice cream is firm. If the temperature in either
compartment is too cold or too warm, change the setting
one increment at a time. Wait 24 hours for the change to
stabilize before adjusting again.
Dispenser
Press the Ice/Water
Select button to select
eitherWater, Cubed
Ice or Crushed Ice. The
selected option
will
illuminate.
Some dripping may
occur after dispensing.
Hold your cup beneath
the dispenser for a few seconds after dispensing to
catch all of the drops.
NOTE: The dispenser will not work if any door is left open
or if the control lock is engaged.
CAUTION: The control display is operated by
touch. Excessive moisture on the display may cause a
malfunction. Please keep the display clean and dry.
Ultra ice
When you press the ice button, the Ultra ice graphic
will illuminate in the display and will continue for 24
hours. The function will automatically shut off after 24
hours.
You can stop this function manually by touching the
button one more time.
This function increases both ice making and freezing
capabilities.
Wafer Filter Reset
CHANGE WATER FILTER
When the water
filter
indicator turns on, you have to
change the water fitter. After changing the water filter,
press and hold the Water Filter Reset button for three
seconds to turn the indicator light off:. You need to change
the water filter approximately every six months.
The Refrigerator Temp Control ranges from 33°F to
46°F (O°C to 8°C). Press the refrigerator temp button
to cycle through the available temperature settings one
increment at a time.
The Freezer Temp Control range is from =6°F to 8°F
(=21°C fa =13°C). Press the freezer temp button to
cycle through the available temperature settings one
increment at a time.
18