Operation; Startup; Using The Comfort Delay Feature; Shut Down - DeVilbiss Healthcare SleepCube Standard CPAP DV51 Serie Guía De Instrucciones

EN

oPeRaTion

Startup

To begin operation, verify that your SleepCube is connected to a 'live' power source. When plugged in, the LCD display
should appear as noted.
Put on your CPAP mask and press the ON/OFF button on the keypad to turn on airflow OR put on your CPAP mask and take a few breaths to
turn on airflow automatically. The pressure in your mask will rise to the set pressure in about 10 seconds.
NOTE
– If the device does not automatically start after taking 2-3 breaths, this feature may have been disabled. If Auto ON/OFF is disabled, you must manually press the
ON/OFF button to start and stop the device.
The keypad display shows the actual mask pressure while the device is in use. Because this is the actual pressure, the
device pressure reading may vary slightly as you breathe. Your display should appear as noted.
If your DeVilbiss SleepCube system includes a humidifier, its heater controls and status are displayed as noted in the
image.
NOTE–
If the display on your device is not similar to those listed above, refer to the chapter section titled "Patient Messages" on page 11.

using The comfort Delay Feature

Your SleepCube has a comfort delay feature to help make it easier for you to fall asleep. The airflow will start at a low pressure and then gradually
ramp-up to the prescribed setting over the last few minutes of the specified delay time.
NOTE–
When the delay comfort feature is activated, a message will flash on the display periodically, indicating the amount of time remaining in the delay.
You can adjust the amount of time spent in comfort delay by using the advanced device controls. The Delay Time can be
adjusted from 0 to 45 minutes in 5-minute increments. Refer to page 9 for details.
NOTE–
If you are unable to change the delay time, your provider has locked this setting. Refer to the keypad menu guide on page 9 for details.
Press the delay button to activate the comfort delay feature. The airflow pressure will drop to the prescribed comfort delay pressure.
In the final 10 minutes of the delay period, the pressure will gently rise to the pressure prescribed for your therapy. You may repeat the comfort
delay by pressing the delay button again if you have not fallen asleep during the first use.

Shut Down

Press the ON/OFF button to turn the device off. You may also simply remove your mask. After a few seconds the device will display the message
"Mask Off. Please check mask fit." If you do not put the mask on again the device will automatically turn off in about 20 seconds. Pressing any
button will remove the message from the display.
NOTE–
If the DeVilbiss SleepCube does not turn off automatically, the "Auto-OFF" feature may have been disabled. In this case you must manually turn the device off.

aDVanCeD menU ConTRols

With the device on, press the "Next" or "Previous" buttons on the keypad to scroll through the items on the display. The table shows the items
you may see, and describes the feature associated with each item.
Name Symbol
PREVIOUS ITEM
NEXT ITEM
SETTING CHANGE
Please note that the values displayed are examples only.
SE-DV51
8
opEration/aDVancED mEnu controlS
Function
Pressing this button displays the previous menu option.

Pressing this button displays the next menu option.


These buttons allow you to adjust the setting that is
shown on the display.

OFF
P:10.0 CPAP
P:10.0 CPAP
Heat:Off
Delay Running
10 Minutes Left