Using The Lower Anchors And Tethers For Children (Latch); Using The Lower Connectors; Using The Energy Absorbing Versa-Tether - Britax HIGHWAY 65 Guía De Usuario

Child Seat Functions
Using the Lower Anchors and Tethers for Children
(LATCH)
The Lower Anchors and Tethers for Children or LATCH, is a system
available on this child seat that offers an alternative to vehicle seat belt
installation methods. See pages 10 and 11 for LATCH components on this
child seat.
LATCH SYSTEM ANCHOR LOCATIONS
Lower Anchors
Tether
Anchor
The figure above shows typical locations for lower anchors and tether
anchors in a vehicle. Check your vehicle owner's manual to learn if it is
equipped with LATCH, the maximum weight rating for the lower anchors,
and for information on the lower anchor locations and seating positions
available for use with this child seat.
Standard vehicle seat spacing between LATCH anchors is 11 in. (27.9 cm).
This child seat can be used in a seating position with up to 20 in. (50.8 cm)
of space between the LATCH anchors if the vehicle manufacturer allows.
16
All manuals and user guides at all-guides.com
Lower
Anchors

Using the Lower Connectors

Where to find the Lower Connectors
The lower connectors are located in the back of the base of the child seat.
Store the connectors in the slots when not in use.
To remove the lower connector from the storage slot or lower
anchor:
1 Press and hold the red release
button.
2 Pull the lower connector from the
storage slot or lower anchor.
To attach the lower connector to the storage slot or lower
anchor:
Firmly push the lower connector into
the slot or lower anchor until a click is
heard.
NOTE: The lower connectors store top
down in the slots.

Using the Energy Absorbing Versa-Tether

WARNING! Failure to follow the guidelines below may
cause the child seat not to perform as intended:
• Britax recommends always using the Versa-Tether when using
the child seat forward-facing. Using the tether will improve
the stability of your child seat and reduce the risk of injury.
• Attach the Versa-Tether only to tether anchors identified by
your vehicle manufacturer as tether anchorage points. Only
use the designated tether anchor for each seating position.
• If your vehicle does not currently have a tether anchor
attachment, refer to your vehicle owner's manual or contact
your vehicle man u f ac t ur e r for assistance. DO NOT modify
your vehicle without advice from your vehicle manufacturer.
• Store the Versa-Tether in the pouch on the back of the child
seat when not in use. DO NOT install the child seat with the
Versa-Tether attached to the carry clip.
Child Seat Functions
Top
®
17