Lap Belt Installation - Britax HIGHWAY 65 Guía De Usuario

Forward-Facing Installation

Lap Belt Installation

Before You Begin:
• Check that your vehicle belt is compatible for use with child
seats. See pages 6 – 8 for more information.
• Remove the Versa-Tether from the pouch and place it up and
over the child seat back.
* Britax recommends that the Versa-Tether is used at all times.
Using the tether will improve the stability of the child seat and
reduce the risk of injury. Check your vehicle owner's manual for
tether anchor locations. Only attach the Versa-Tether to anchor
points designated to the chosen seating position as indicated by
your vehicle owner's manual.
• Adjust this child seat to position 1 or 2 and place forward-facing
on the vehicle seat (see page 15).
* Ensure that no more than 20% or 3 in. (7.6 cm) of the base hangs
over the edge of the vehicle seat.
Install with the lap belt as shown above.
IMPORTANT:
• DO NOT use lock-offs for lap belt installations.
WARNING!
• Your child seat may not perform as intended if the base of the child
seat is not flat on the vehicle seat.
• HUGS chest pads must be installed when using the child seat in a
forward-facing position.
30
All manuals and user guides at all-guides.com
Loosen the harness.
1
a Lift harness adjuster lever
b Pull both harness straps forward
2 Remove the body pillow and
unbuckle the harness.
Lift the back cover, then pull the
3
seat cover forward to access the
forward-facing belt path.
Route the vehicle seat belt
4
through the forward-facing belt
slots, then buckle. Ensure the
vehicle belt is not twisted.
Push down on the middle of the
5
the child seat while pulling the
vehicle belt to remove all slack.
Attach the Versa-Tether to a
6
designated anchor (see vehicle
owner's manual) and remove
slack (see pages 17 – 19).
Store the excess webbing in the
7
elastic strap.
Replace the cover.
8
Checklist
9 Check that the vehicle belt is securely fastened.
9 Check that no more than 20% or 3 in. (7.6 cm) of the base hangs over
the edge of the vehicle seat.
9 Check that the child seat cannot be moved front to back or side to side
more than 1 in. (2.5 cm) at the belt path. If the child seat is not secure,
repeat installation or use a different seating location.
9 Check that any excess Versa-Tether
vehicle and secured in the elastic strap.
Forward-Facing Installation
1b
1a
4
webbing is contained within your
®
31
5