Sears Kenmore Elite 106.5177 Serie Manual De Uso Y Cuidado página 15

Installing the Produce Preserver (on some models)
CAUTION: IRRITANT
MAY IRRITATE EYES AND SKIN. DANGEROUS FUMES
FORM WHEN MIXED WITH OTHER PRODUCTS.
Do not mix with cleaning products containing ammonia,
bleach or acids. Do not get in eyes, on skin or clothing. Do
not breathe dust. Keep out of reach of children.
FIRST AID TREATMENT: Contains potassium
permanganate. If swallowed, call a Poison Control Center or
doctor immediately. Do not induce vomiting. If in eyes, rinse
with water for 15 minutes. If on skin, rinse with water.
For best performance, always use two Produce Preserver pouches. Both
pouches should be installed in the same housing assembly, which is located
along an interior side wall of the crisper and/or convertible drawer.
NOTE: There are two housing assemblies. Use one for the CrisperKeeper™
Produce Preserver pouches, and use the other for one of the CleanFlow™
Air Filters. Do not install Produce Preserver pouches and Air Filters in the
same housing assembly. See "Install CleanFlow™ Air Filters" for additional
information.
1. Remove the Produce Preserver pouches from their packaging.
2. Lift up on the housing in order to remove it from its mounting tab
along the wall.
3. Open the housing by pulling up and out on the back of the top
of the housing.
4. Place both pouches inside the housing, then snap the housing back
together.
5. Place the housing back on the mounting tab along the wall.
Installing the Status Indicator (on some models)
The Produce Preserver comes with a status indicator, which should be
activated and installed at the same time the pouch is installed.
MONTHS
1. Place the indicator face-down on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator, until the
bubble pops to activate the indicator.
3. Slide open the cap on the Produce Preserver housing.
4. Place the indicator in the top of the housing, facing outward.
5. Slide the cap closed, and check that the indicator is visible through
the rectangular hole in the cap.
NOTE: The cap will not easily close if the indicator's rear bubble has
not been popped.
Replacing the Produce Preserver (on some models)
The disposable pouches should be replaced every 6 months, when the
status indicator has completely changed from white to red.
To order replacements, see "Accessories."
1. Remove the old pouches from the Produce Preserver housing.
2. Remove the old status indicator.
3. Install the new pouches and status indicator using the instructions
in the previous sections.
REPLACE
15